ULKA 泵型号 EFP5~120v 60hz 2/1 分钟，52W，适用于 Breville Espresso
|5 星 (0%)||0%|
|4 星 (0%)||0%|
|3 星 (0%)||0%|
|2 星 (0%)||0%|
|1 星 (0%)||0%|
美国亚马逊： 32 条评论
Used with Brevile BES870XL2018年4月24日 - 已在美国亚马逊上发表
Works good with Brevile BES870XL machine. I think it’s a bit more powerful than the original. Overall good pump.
Turbo pump for Delonghi espresso maker2019年11月25日 - 已在美国亚马逊上发表
If you are looking to repair an espresso maker and give it a bit of a boost, this pump is a plug-and-play replacement for the 42W pump found in the Delonghi and many other brands. It makes much more foam and is quieter than the original. You must have some experience fixing small appliances, or at least the guts to give it a try, but be sure to keep track of the "hot" wire when you disconnect power from the back (inside) of the switch to remove the assembly. And, it is very important to be sure to test for current with a multi-meter between the housing and ground after reassembly to make sure that you can't get a shock, which is what will happen if you put the wires back in the reverse. You'll also need a long-shaft, security Torx T-20 bit to remove the lower part (stand) from the upper part. You may also need to buy a length of 5/16" OD food-grade tubing to put it all back together if you are clumsy like me and nick the tubes. This part does not replace the bypass valve assembly, but the old one screws off with some effort after moving various parts out-of-the-way. I found it easiest to put the pump and tank assembly back into the housing and then screw the bypass valve onto the pump, then reattach the hoses. It took about 4 hours all together, not including trips to the hardware store and O'Reilly's to get the Torx wrench.
Direct replacement for my Breville BES-920XL2019年1月30日 - 已在美国亚马逊上发表
The pump was failing in my Breville, and the factory approved options were ridiculous to get it fixed. 20 minutes of time and this pump and it is better than it was new.
Great replacement2019年11月23日 - 已在美国亚马逊上发表
I was able to replace the original pump in the breville espresso maker. The original rusted and failed due to an o-ring failure on the discharge tubing The water leak dripped down and in time rusted the pump. Now it works good as new after 7 years.
Install for Breville bes870xl2020年2月9日 - 已在美国亚马逊上发表
I used this to replace the pump in my Breville bes870xl expresso machine when it failed after four years of use. This pump is the same exact model found in the Breville bes870xl. The install was easy (I just watched YouTube videos), and my espresso machine runs like a champ again.