画框仿古金带串珠细节 .3.81 cm 宽 深金 20 x 24" WOMD6301-20x24
- 配有玻璃（16x20 或更小）或有机玻璃（16x20 或更少）和用于墙壁安装的挂钩！
这是一款全新的图片、照片、文凭、海报框架。 这款复古金镶珠细节相框采用实木嵌条制成，厚度为 3.81 cm，槽口（边缘到相框底部的空间）深为 112.07 cm（边缘到相框底部的空间），精心打造，符合行业*高标准。 随附画框。 这款设计师画框非常独特，您在大多数画框店铺都找不到。 框架非常适合照亮您*珍贵的图片、照片、艺术画廊、海报、照片、绘画、文学、艺术作品、针点等，但也足够匹配任何环境。 这款复古金镶珠细节框架完美搭配黑白和彩色图片或绘画。 其是一件不错的圣诞礼物！ 请随时浏览我们的策略和反馈。 如果您不确定这是您想要的框架，请随时使用本页顶部的搜索搜索 ArtToFrames 查看我们种类繁多的木质画框、金属画框和预制画框。 不要忘记将我们添加到*喜爱的商品中，所以您无需在下次需要画框时再次搜索我们！
|5 星 (0%)||0%|
|4 星 (0%)||0%|
|3 星 (0%)||0%|
|2 星 (0%)||0%|
|1 星 (0%)||0%|
The packaging was horrible. It was wrapped in plastic wrap and stuck into cardboard instead of any padding or bubble wrap. Mind you these WERE bought buy the actual company Art To Frames, AND they were even stamped on the box it came in.
Yes, this is in part the UPS's fault, however with proper packaging these would have been fine. I HIGHLY recommend staying away from this, as it's going to be VERY hit or miss, and please DO NOT put anything of real value in here. The backing was cardboard that was uneven and would cause damage and bends in your print (mine are hand pulled cotton prints from an artist) and the plexi is VERY thin and bends easily.
The frame itself is also very fragile, and bends EXTREMELY easily. This is again due to the very cheap materials they used to make these.
Now, I wouldn't have been as surprised but on their website these are nearly $100 frames.
If this was $20 a frame, I wouldn't be surprised, but these are $50 and $65 frames here on amazon.
AS FOR LOOKS: This is another key factor. The frames I ordered don't look like what I ordered hardly at all. The dimensions given in their description of how wide and deep the frame itself is are both wrong.
PLEASE BE CAREFUL if you are looking for a cheap solution to an expensive/ semi expensive print or poster. I would recommend only putting things costing around $10 in this or things that you can have remade. My prints are not very expensive but are limited (both out of 25) from an artist and would be unable to be replaced.
I'm a stickler for framing my paintings with real wood. I ordered two "solid wood" frames from a large art supplier (who shall remain nameless because they eventually agreed with me) for a commission. When they arrived a few weeks later, they were obviously cast resin. The company wasn't responsive to my emails, and meanwhile the deadline was inching closer. The resin frames looked so cheap in person, I couldn't bring myself to use them.
I remembered that a frame I'd gotten from ArtToFrame before was real wood, and ordered one. It delivered almost a week earlier than estimated (perhaps because I live relatively close). They may be narrower than many frames, perhaps because they are wood. They are made in the USA, which I appreciate. The company also has an ingenious, very secure, cardboard packing system that can be easily recycled (the resin frames left me with a trash bag filled with unrecylable packing material).
The plastic front (what used to be glass) is a thin flexible sheet of clear plastic. In the instructions, they tell you that "one or both" sides of it is covered in a plastic layer that needs to be peeled off. Well my husband and I both tried and tried, with our fingers, with our nails, with strong tape, with pins, with tweezers, and we could not get any plastic layer off. Either it's not on there - in which case, they need to send accurate instructions - or it's darned near impossible to remove.
The plastic sheet also had a couple of markings (light scratches) on it that I couldn't get out. And they're positioned so that one or the other of them is going to end up right over my son's head.
On the plus side, the frame itself is as gorgeous as I'd hoped (thus the two stars) and it came well packaged. Don't buy this if you're in a hurry though because it takes some time to arrive.
I was disappointed that I had to measure, place, and hammer in the sawtooth hanger myself. Needless to say, Martha Stewart would not be impressed. The packaging said I could choose between sawtooth and the included wire hanger assembly. But there was no wire hanger assembly included. A shame because with my skills, that would have resulted in a more perfect hang.
If you can find another frame you like, buy it. This one's a pain in the a** and the "glass" front may have noticeable scratches. But if you can't, this'll do. Just set aside some time and patience. And if you don't find any plastic sheet to remove from the glass panel, don't sweat it. It's probably not there.