- 商品尺寸: 4.8 x 4.8 x 27.9 cm
- 商品重量: 200 g
- 发货重量: 204 g
- ASIN: B01LZTKKU3
- 用户评分: 分享我的评价
胶压力敏感 styrene 床单适用于制作 DIY lampshades IN A pre-cut 长度
尺寸: 10" High x 40" Wide
|5 星 (0%)||0%|
|4 星 (0%)||0%|
|3 星 (0%)||0%|
|2 星 (0%)||0%|
|1 星 (0%)||0%|
美国亚马逊： 125 条评论
Love this stuff!2016年4月29日 - 已在美国亚马逊上发表
I have a 1990 RV and couldn't find replacement 1/2 shades for two wall sconces. Used this to redo the old ones. Took the old ones apart, used it as a pattern on how to cut the styrene sheet. Used a cutting wheel and exacto knife. Worked perfect. Even if you're not a crafty person, you could use this. Then I used tacky glue to finish it off. See the results for yourself...before on the left, after on the right.
Easy to use2019年8月21日 - 已在美国亚马逊上发表
Super easy to use. I got a piece twice the height I needed so I could cut it in two and make it longer. I used it to line the inside of a light fixture that cast sparkly light in a way I didn't love. I didn't add any fabric to it, so it's just a semi-opaque white. It tones down the light perfectly and looks nice. I adhered it directly to the light fixture and it's holding great.
I had accent lamps in my fifth wheel that had ...2016年5月16日 - 已在美国亚马逊上发表
I had accent lamps in my fifth wheel that had ugly western shades in it. I couldnt find any shades that would work with such a small spider fitting requirement I needed. I was able to use the old fittings and make new shades. I needed 5 of them.
"Curly" so flatten it out first.2019年11月22日 - 已在美国亚马逊上发表
I used some gauze type fabric. Lay out fabric and leave a few inches around the edges and trim. I used some heavy pots and pans to hold it down. Score the paper backing about every 10-12" with exacto knife and press one section at a time. I used a wood ruler press styrene onto fabric. There were a few creased areas but I was able to loosen in those areas to remove creases. Then trim the excess with exacto knife. I didn't leave extra fabric, as I did a laced shade but leave extra if you will be gluing to the rings.