Century Drill & Tool Rethreading 六角形骰子 1-8 NC 92919
- Rethreading hexagon dies for repairing damaged bolts or studs
- Rethreading dies are made from high carbon alloy steel for a long tool life
- Made in the USA
- National Coarse
|5 星 (0%)||0%|
|4 星 (0%)||0%|
|3 星 (0%)||0%|
|2 星 (0%)||0%|
|1 星 (0%)||0%|
美国亚马逊： 61 条评论
Worked great on the output shaft of a Jag Compact A-Type Overdrive2018年3月10日 - 已在美国亚马逊上发表
Worked great to clean up rusty threads on the output shaft of a Compact A-type Laycock-DeNormanville Overdrive that had been sitting outside exposed to the elements. The cotter pin had rusted solid so I had to break it off and use an impact driver to remove the castellated nut which should have been able to be removed by hand after loosening. Needless to say the threads were a rusty, damaged mess. The output shaft on these is part of the Annulus and it's expensive to replace and hard to find. I woulda been pretty well buggered if this die didn't clean it up. I coated the threads liberally with Tap Magic cutting oil and carefully and slowly spun this die home by hand. After tightening it up and down a few times I'm happy to say that the threads are now in good shape. The nut can be easily turned all the way by hand - as it should be. This nice little die saved my sanity and a very expensive vintage car part!
Restores damaged threads2020年2月8日 - 已在美国亚马逊上发表
This rethreading die (7/8 -14NF) is indispensable when working on a Jeep JK Dana 44 differential. The Dana pinion nut is softer than the pinion shaft and is designed to deform as it is tightened. This leaves pieces of the nut imbedded in the pinion threads. If you try to put a new pinion nut on without first removing the old nut debris the new nut will jamb and strip before you can get sufficient preload on the bearings. By cleaning the pinion threads with this die your new nut will start easily and will tighten with the force you need.
A quality Die for chasing threads.2019年11月18日 - 已在美国亚马逊上发表
Received wrong Die , due to package marking error. This was not Amazons fault. Received correct one and returned wrong Die. Amazon was great about this and promptly sent correct one. A testiment to Amazon service. Die worked flawlessly on chasing wheel stud bolts on a Steiger tractor. Thanks Amazon.
Saved my a&&2019年4月10日 - 已在美国亚马逊上发表
I replaced the bearings on my mower, and damaged the threads, because I am in fact a moron. Rather than paying almost a hundred a spindle to replace them, I bought this bad boy and repaired the threads. I doubt it'll last in an industrial setting, but if that's your need, you need to drop more money anyway.