Got my bit yesterday. I had a total of 5 holes to make... it made it through 3 pretty well. However, by the fourth hole I noticed it was taking much longer to cut through the rebar. I was not even able to get through the 5th one. I may have been running the drill at to high of a speed as one of the other reviewers mentioned to run it slow and have good feed pressure.
As another poster mentioned. Mine wobbles pretty badly at this point. I just cant recall if that happened right out of the box.
Two stars because it did manage to cut through rebar but seemed to have dulled prematurely, so I'm left to figure something else out with the last hole I need to drill.
Bosch 直柄刀柄刀 9/16-Inch RCSS2094
- High Quality Rotary Carbide - For long drilling life
- Tapered Shank Body Design - Less weight for smoother drilling
- Unique flute geometry removes metal shavings quickly
|5 星 (0%)||0%|
|4 星 (0%)||0%|
|3 星 (0%)||0%|
|2 星 (0%)||0%|
|1 星 (0%)||0%|
美国亚马逊： 6 条评论
Bosch rebar cutter does the job2013年10月29日 - 已在美国亚马逊上发表
Every one said that the only way to get through rebar was to grind or cut with a torch! No so. The Bosch rebar cutter goes right through rebar. I had to put some bolts through a pipe that had rebar inside. No matter how new or sharp my drill bits were the only thing that happened when I would try to cut though the rebar was that the bits would become very dull and very polished on the end. The Bosch rebar cutter cut through with great speed and showed no signs of dulling even after many, many uses!
Five Stars2017年12月28日 - 已在美国亚马逊上发表
These work best when using low rpm (about 100-150) and LOTS of feed pressure.
POS2015年8月16日 - 已在美国亚马逊上发表
They were Bent at the shank out of the package both of them one not as bad as the other we couldn't shut the job down so we used them they lasted about 6 maybe 8 holes before they were useless