PORTER-CABLE Forstner Bit 2-Inch POR-6328
|5 星 (0%)||0%|
|4 星 (0%)||0%|
|3 星 (0%)||0%|
|2 星 (0%)||0%|
|1 星 (0%)||0%|
美国亚马逊： 26 条评论
I'm underwhelmed but maybe my expectations are too high. ...2016年8月2日 - 已在美国亚马逊上发表
I'm underwhelmed but maybe my expectations are too high. I'm including pics so you can judge for yourself. The set of forstner bits I inherited leave a very smooth flat bottom hole. Maybe they're high end...I don't know the brand. However, this bit left scratches on the flat bottom hole that needed a fair amount of sanding. Also, the bit bogged down and stopped my drill press on the 4th hole, which I was only drilling to a depth of 3/4". Granted, it's only a 1/2hp drill press but my old bits (up to 2") have never bogged down the press. Amazon did authorize a return but estimated the refund at $5. For my use, I would not buy this bit if had know how it would perform.
cuts well, nice quality2017年11月2日 - 已在美国亚马逊上发表
used it for cutting holes in sliding doors for the recessed round handles,, on hollow doors,, works great after a few doors, stayed sharp,, looks like a real PC tool,, I am a hobbyist but feel this would hold up for a while in a commercial environment,, the starter screw could be a bit longer so keep a steady hand and start slow,, after that your good to go..
Raymond E. Schwartz
I did some end grain boring for candle sticks and pepper mills2017年6月3日 - 已在美国亚马逊上发表
I purchased a couple of these to replace one from the original set. I did some end grain boring for candle sticks and pepper mills. I my have damaged the first one by boring two slow and allowing the heat to build up. Since then I've learned to reshape my these bits. Well maybe, proof will be in the doing. Not bad for a retired hobbyist but I'd go for a better one if I did this stuff for a living.
Quality product from quality company2017年1月17日 - 已在美国亚马逊上发表
Excellent product as usual from Porter Cable. I am very happy with my purchase of this Forstner bit from Porter Cable. Excellent product, held up well to 32 holes through 3/4" wood. Took a long time, slow and steady, big holes are tough to do but this bit was up to the task, nice clean cut out. Definitely think that my arm and hand will give out long before the bit does.
Good price, quality tool.2017年12月3日 - 已在美国亚马逊上发表
Good price on a quality tool. Just remember to read the directions and use low RPMs with this tool or you will dull it to uselessness on the first use. This isn't a limitation of the bit, just the physics of friction heat produced with a 2 1/8 wide bit.