- SOG 六角钻刀
- Sog 多功能工具附加件
- 内含 12 个六角钻头，便利携带箱
- 位尺寸 - Torx T6、T8、T10、T12
- Philips 1、2、3
Hex Bit Accessory Kit
This Hex Bit Accessory Kit increases the possibilities for any SOG multi-tool that comes with a 1/4" driver or a hex socket. With 12 interchangeable bits (Phillips, Flathead and Star-drive) that fit most common fastener heads, your SOG tool just became a tool chest
Holder w/ Lanyard Loop
Convenient holder houses all the bits in one place.
Includes Phillips #1, #2, and #3 bits.
Includes Star-drive T6, T8, T10, and T20 bits.
Includes Flathead #3, #5, and #7 bits; and Hex 1.5mm and 2mm bits.
|Length||Width||Weight||1/4" Socket to Hex Bit Driver||Star Drive Bits||Phillips Bits|
|5 星 (0%)||0%|
|4 星 (0%)||0%|
|3 星 (0%)||0%|
|2 星 (0%)||0%|
|1 星 (0%)||0%|
It's nice to complete the set, but really any set you have lying around will work. An adapter that was made specifically for this driver would complete this. As-is, it's merely okay.
I have two concerns though.
1. The plastic bar in which the tools fit has holes a tiny bit larger than the tools. Great for getting tools out, but bad for keeping tools in!! A few of the bits keep falling out of the plastic holder anytime I pick up the set. I just KNOW those pieces are going to get lost SOON. :( It would be better if the holder was more rubbery (less hard plastic) so it would grip the bits enough so they wouldn't fall out, but still allow one to pull them out when needed.
2. There is no convenient way to carry these tools with the SOG tool itself. It MIGHT be possible to jam this inside the same sheath as the SOG tool. HOWEVER, since the sheath is open at top and bottom and the bits inside the plastic housing are loose, those little bits are going to slip out of the plastic housing, drop right through the sheath opening and will be gone forever. The second problem is, you could not get the SOG tool out of the sheath without also removing the bits, so then what do you do with the bits while you're working with the SOG tool?
I guess the only answer is a SEALED secondary sheath of some kind for this tool accessory, so the little bits aren't lost when they slip out of the plastic holder, and they don't interfere with grabbing the SOG tool by itself. I wish it came with that little sheath! :)